We are proud to present our new range of hi-end chargers from GT, these are incredible little chargers with lots of advanced features perfectly suited to charging large Lithium Polymer packs! The V6 can charge at up to 12 Amps into a 6 cell pack, this means 1 hour to charge our 12Ah packs, 80 mins to charge our 16Ah packs!


Run two of these chargers off the E-FUEL power supply to charge both packs from your 2Kw setup at 10A charge rate per battery!



The screen is an awesome 2.4 inch IPS TFT High Definition colour screen, the scroll button makes programming easy. Charger has XT60 input and ouptu connector as well as balance lead input. We supply the V6 unit with an XT60 input lead with 4mm bullets fitted ready to connect to the power supply and an XT60 female to XT90 male harness that matches all our battery packs. Harnesses do not come with the charger as standard.


This package includes a genuine Australian imported and c-ticked 30A E-Fuel power supply with one GT-V6 charger. You can purchase more GT-V6 chargers if you want to run two together, additional chargers are $90.00ea.



One key shuttle control

Input Voltage: DC 7-28v

Battery type: LiHV/LiPo/LiIon/LiFe/Nimh/NiCd/Pb Lixx: 1-6s, Nixx: 1-16s, 2-24v for Pb (lead acid)

Charge output: 16a / 300w max

Discharge power: 3.0a / 5w max

Balacing Current: 1.0a max

Dimension: 80 x 80 x 32mm



eFUEL 540W/30A Regulated Power Supply

High Power - High Output

Over Temperature Protection

Over Current Protection

Short Circuit Protection

SkyRC eFUEL 540W/30A DC power supply is designed to power your DC power equipment. Itís capable of converting standard household 100-240V AC to 12-18V DC. Continuous current up to 30 Amps.

Dual DC Power Outputs, can run two DC chargers simultaneously.








Riding an Electric bicycle can be a dangerous activity, OZ-eBikes cannot be held responsible for accidents or injury caused by your use of these products. Our warranty responsibility is limited to the products supplied only, and warranty is provided for the supplied products only if they are used as intended. Any modifications to the equipment, use of incorrect batteries or chargers etc will void the warranty.


Lithium batteries are dangerous and must be handled with care, if they are dropped and there is visible damage or deformation of the case you should seek expert advice before continuing to use the battery.


We highly recommend purchasing a small $10.00 steel toolbox from Bunnings or BigW to store your batteries in when not in use. Batteries should be stored outside the house. Batteries must be charged with a specified LiPo charger, we are not responsible for any issues that arise if you use a charger other than the ones we recommend. Our chargers are computer controlled and have advanced settings to ensure the battery cannot be left charging continuously, our chargers automatically shut off when the battery is fully charged. Regardless of this you should NEVER leave a battery unattended when charging, always be within the vicinity and check on the progress regularly.


OZ-EBIKES checks and records the battery pack voltage for every Lithium battery pack before we send them out. OZ-EBIKES then warrantees all packs to have proper assembly and cell voltage at time of purchase. In the event that a customer finds defects in materials or assembly workmanship when the goods are received but unused, OZ-EBIKES will replace such packs within Australia after inspection if they are deemed to be faulty.

OZ-EBIKES does not offer a general warranty for battery packs which have already been charged and discharged, or for which claims are made more than one week after receipt of said battery packs by the customer. Because the majority of Lithium Battery problems occur after initial use and are due to over charge/discharge of the packs, it is in most cases difficult to determine the cause of failure, and requires inspection by the manufacturer.


For packs that have been used and which the customer believes are defective, OZ-EBIKES & their manufacturer have agreed to have these inspected at the factory, and replaced if defects are found. In the event that the pack is found not defective or has been damaged by misuse, the pack may be returned to the customer if desired, at the customer's expense.


There is no warranty, expressed or implied, by the manufacturer, distributors or retailers with respect to capacity, life in cycles, storage or discharge characteristics available.


By purchasing any complete kit or individual parts from us you agree to these terms and conditions.